A data centre runs 24/7, and any break in supply hits the IT infrastructure. How to specify rack-end sockets, why interlocked types and Type A RCDs matter, and how to lay out industrial Ethernet.

Wash-down in food, beverage and central-kitchen areas means hot high-pressure water and detergent — even IP67 may not be enough. IP69 versus IP67, and how to specify for wash-down zones.

Logistics sites mix very different loads: high-current forklift charging, reefer containers at the dock, sub-zero cold stores and sorting lines that cannot stop. How to specify each area, with our models.

Welding, press and paint lines and test benches draw 200A–400A. At that level "it fits" is only the start — contact quality, heat dissipation and cable weight are what matter.

Wind farms are remote, coastal and high up: salt corrosion, continuous vibration, wide temperature swings. How to specify maintenance power in the tower and nacelle, and why IP67/IP69 and mechanical interlocks come first.

Mines, processing plants and heavy fabrication share the same conditions: heavy dust, frequent wash-down, high-current equipment and rough handling. How to fix the IP rating, why a mechanical interlock is mandatory, and what to watch on high-current terminals.

Platforms, maintenance depots and depots need connections that are adequate and mistake-proof. Why interlocked, higher-IP devices come first in public areas, and what a depot typically needs.

Shipyards and ports combine aggressive corrosion, open-air exposure, weld spatter and high current. How to choose IP rating and materials, and what welding areas need.

Event power has three traits: very little time, equipment that moves, and lots of people around. How to choose portable power boxes, why an RCD is mandatory, and what matters when wiring a stand.

In machining, assembly and packaging plants, 90% of the demand falls into four categories: workstation power, equipment supply, maintenance and temporary power. The standard configuration for each.